AK Builder 7.62 5.45 Receiver Blank Drilling Fixture

(1 review) Write a Review
AK Builder Receiver Blank Drilling Fixture

This receiver blank drilling fixture is made specifically for the Polish 7.62x39 and 5.45x39 receiver blanks. Helps drill out the hammer pin, trigger pin, selector lever, center support and trigger guard holes. Includes a 5/32", 7/32", 5mm, 7mm and 10mm drill bit. The stop pin for the rear of the trigger opening is the key to getting the receiver aligned in the fixture. Heat treated to last through the drilling of several blanks. MADE IN THE USA

NOTE: Will NOT work on a Polish Tantal since the selector hole is in a different spot.

1 Review Hide Reviews Show Reviews

  • 5
    Best AK Drilling Jig

    Posted by Antonio90 on Jun 4th 2016

    I needed this jig for some 80% blanks. The 5mm & 7mm fire control holes drilled so smooth with WD40 at 730rpm on the drill press that I didn't need to buy chucking reamers. Everything lined up accurately when compared to an original select fire receiver from Poland. Unlike other jigs, this one secures the blank to the jig with a bolt eliminating C-clamps which get in the way while drilling. If you're a beginner or experienced builder, I highly recommend this jig.